Electrical Engineering Fundamentals By Vincent Del Toro Pdf [verified] 🎁 Hot

Duration: 3 hours Total points: 200

Part D — Essay & synthesis (20 pts) Choose one of the two prompts (answer thoroughly, ~300–500 words): electrical engineering fundamentals by vincent del toro pdf

Problem 6 — Three-phase & power (12 pts) A balanced Y-connected load: Z_phase = 10∠30° Ω, supplied by a 208 V (line) three-phase system. a) (6 pts) Find phase and line currents (phasors) and per-phase real, reactive, and apparent power. b) (6 pts) If one phase goes open (unbalanced), describe qualitatively what happens to neutral current and load voltages. Duration: 3 hours Total points: 200 Part D

Problem 4 — Resonant circuits & bandwidth (12 pts) A series RLC has R=20 Ω, L=100 μH, C chosen so resonant frequency fr = 1 MHz. a) (4 pts) Find C. b) (4 pts) Compute Q factor and bandwidth (BW). c) (4 pts) If R is halved, state qualitatively how fr, Q, and BW change. Problem 4 — Resonant circuits & bandwidth (12

Problem 9 — Practical measurement & instrumentation (15 pts) You must measure a small AC voltage (peak 20 mV) in presence of large common-mode interference (~10 V) using an instrumentation amplifier built from op-amps. a) (6 pts) Sketch the schematic conceptually (describe stages: input filtering, INA, gain, common-mode rejection). b) (5 pts) Choose an INA gain to get ~2 V full-scale output and compute resistor values or gain-setting component. c) (4 pts) List three practical techniques to maximize CMRR and reduce noise in this measurement.

Problem 3 — AC steady-state & phasors (18 pts) Given: Vs = 10∠0° V, series network: R=50 Ω, L=100 mH, C=10 μF, frequency f=1 kHz. a) (6 pts) Convert L and C to reactances; compute total impedance Z and current phasor I. b) (6 pts) Compute voltage phasors across each element and verify KVL. c) (6 pts) Compute real power delivered by the source and reactive power.